Extruded Faces Are Backwards?

[grobermatic]

Hi All,

When extruding a line into a face (drawing imported from AutoCAD) I find that some of the faces face one way and some the other way. This results in apparent holes all over my model. Is there a way to make both sides of the face show?

Thanks


Craig

--------------------------------------------------------------------------------------------------------
"Time-traveling is just too dangerous. Better that I devote myself to study the other great mystery of the universe: Women!" .. Dr E. Brown (1985)

 

[leonec]

apply a material and check the box in the mateditor that says "2 sided" then apply the material.

This isn't the best solution...you really should take the time to flip the normals into the right direction. you can do that in the mesh editing mod.

 

[grobermatic]

hi again ... thanks

craig

--------------------------------------------------------------------------------------------------------
"Time-traveling is just too dangerous. Better that I devote myself to study the other great mystery of the universe: Women!" .. Dr E. Brown (1985)