I have a junk 350 that I'm spending way too much time fooling with, that I finally managed to get through all it's warm up paces, only to find I'm unable to clear the head. This one has many blank stripes on the clean test page. I've used a heart breaking amount of ink in self-cleaning modes, even raising the head temp then cleaning all for naught.
Before I either scrap this thing or take my chances with a used replacement head, is there some un-orthodox last ditch way to attempt a head clean? I tried scrubbing with cloth and naptha, nothing, alchohol, nada.
I got a few jets cleared by clamping a silicone rubber suction cup in a pair of surgical clamps and pulling ink through while the head was hot, simulating an extreme cwp.
But after a little while the suction cup gave out in the heat.
ANyone try boiling the head in a vat of gasoline, or soaking it in hot acetone for several hours? I wonder...
Before I either scrap this thing or take my chances with a used replacement head, is there some un-orthodox last ditch way to attempt a head clean? I tried scrubbing with cloth and naptha, nothing, alchohol, nada.
I got a few jets cleared by clamping a silicone rubber suction cup in a pair of surgical clamps and pulling ink through while the head was hot, simulating an extreme cwp.
But after a little while the suction cup gave out in the heat.
ANyone try boiling the head in a vat of gasoline, or soaking it in hot acetone for several hours? I wonder...