Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations SkipVought on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
external forward on legend rel 3 v10
- Thread starter liseanne
- Start date
TouchToneTommy
Vendor
What release? You may have to do it through remote access, which you can set up by looping a Tip/Ring station to a Line port.
Of course, make sure the phantom has RCF and Trunk to Trunk enabled.
Of course, make sure the phantom has RCF and Trunk to Trunk enabled.
- Thread starter
- #3
dagwoodsystems
Programmer
I've always used Remote Access to do this. Dial in and enter the barrier code. When you hear the Merlin tone, dial *33 [tone is heard] adjunctExt [tone again] destinationExt [dah-dah-dah confirmation tone].
Absolutely check the RCF and T2T Xfer options as Tom suggested.
Tim Alberstein
Absolutely check the RCF and T2T Xfer options as Tom suggested.
Tim Alberstein
TouchToneTommy
Vendor
It is too early a release to use authorization codes for RCF - so you'll have to go with DISA
- Status
Similar threads
- Locked
- Question
- Locked
- Question
- Locked
- Question
