Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations strongm on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

External follow me malfunction

Status
Not open for further replies.

tinutzu

IS-IT--Management
Oct 25, 2004
9
RO
Good afternoon,
I have a system with few routes, a route with connection in public exchange and other for mobile phone (with Nokia Premicell). I have initiate a answering position for route connected to public exchange. For night I need to redirect the incoming calls (via public exchange) to a mobile phone. This work, but only once time. The conversation can be established, but after both parts hang up, the traffic remains in speech and line is busy. The single posibility to free traffic is RFBOI for TLU75 board or RFEXI.

<ROCAP:ROU=ALL;
ROUTE CATEGORY DATA
ROU SEL TRM SERV TRAF SIG BCAP
3 713000001000001 4 3101000000 00151515 211110000000 001100
5 113010000000001 4 1000000000 00151515 200010001000 001100

ROU=3 - public exchange
ROU=5 - mobile phone

RODAP;
ROU TYPE VARC VARI VARO
3 TL11 H'00000002 H'00000188 H'00000815
5 TL11 H'00001010 H'00000C04 H'00041015

Best regards


 
This is because there is no clear signal from your public provider. Ask for this and reprogram your parameter to detect clear signal.
 
Patcher,

This is TL11 as for incoming and for outgoing.
It will newer detect clear signal.

tinutzu,
You CAN't use this service with your signalling.
Your call will stay connected very long time...

No problem with QSIG or ISDN.

Regards
 
What are you talking about Avstral? Did you checked your documents before you response to this forum. Check again the VAR parameter specially VARO.
 
Thank you for your response. I'm not good to program the routes. So, what can I do, to work fine?
 
Hi, all!
to Patcher
do you mean parameter D7 VARO (BC9) "Receive clearing signal from interworking exchange (polarity reversal)"?

Thanks, HIREI
 
Hirei, yes thats it but you should set SIG parameter to handle it. Var to enable the board and SIG to enable the software.
 
Well! It's great! Common wisdom was not to set (re)routing from TLU75 pair to TLU75 pair, I heard it even from local reseller.

Thanks, patcher.

 
patcher,

1. I did check documents before response to this forum.
2. Working with MD last 13 years in 3 counties, I've never seen provider, who could give polarity reversal on subscriber lines or wich to discuss this question.
Only on coin boxes.
3. May be the word "newer" is too strong from my side and you have positive experience in your country, but could you be more polite in public forum?
4. Take is easy, buddy! :)

Regards
 
Dear Patcher,
You say that my local provider not send the clearing signal?
Best regards
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top