External Dialtone

[ursusK]

In our MD110 we had before, one could hear a difference in dialtone when it was internal or external.
So when a user picked up the phone he would hear a different dialtone if he would press '0' (to get an outside line).

In our new md110 BC12 the dialtone sounds the same inside as outside.

Is there a command to change this? Is this dangerous to do?

Many thanks in advance !

Björn

 

[testcentre]

i would check the setting of the SIG parameter in the route category.

 

[ursusK]

Sorry, how would i do that? (I'm rather new in de md110 world)

 

[MDadmin]

Hi ursuk,
you could check parnum=254,but rememeber after any changes restart TMU board to activate new tone.

 

[MDadmin]

Hi ursuk,
you could check parnum=254,but rememeber after any changes you must restart TMU board to activate new tone.

 

[MDadmin]

Hi ursuk,
you could check parnum=254,but rememeber after any changes restart TMU board to activate new tone.

 

[mduser110]

Hi ursuk,
you could check parnum=254, but remember after any changes restart TMU boards to activate new tone.

 

[MDadmin]

Hi ursusk,
you could check parnum=254,but remember after any changes restat TMU boards to activate new tone.

 

[whosrdaddy]

UrsusK :

copy & paste printout of following commands :

RODAP:ROU=x; //replace x with the QSIG route number
ROCAP:ROU=x;
RODDPEST=ALL;

--------------------------------------
What You See Is What You Get

 

[ursusK]

This is the output.. Hope it helps..

VERSION=CXP1010111/1/BC12SP3/R4A


14:02:52
TUE 10 AUG 2004
END

<
RODAP:ROU=ALL;
ROUTE DATA


ROU TYPE VARC VARI VARO FILTER


1 SL60 H'00000340 H'10020000 H'24410000 NO
2 SL60 H'00000340 H'10020000 H'24410000 NO


END

/* SUCCEED 14:02:55 */
/* MML_TTY_COMMAND 14:03:35 [NLGBS01] Admin */
ROCAP:ROU=ALL;
ROUTE CATEGORY DATA


ROU SEL TRM SERV NODG DIST DISL TRAF SIG BCAP


1 7110000000000010 5 3101000101 0 30 128 03151515 511100000030 111100
2 7110000000000010 5 3101000101 0 30 128 03151515 511100000030 111100


END

/* SUCCEED 14:03:36 */
/* MML_TTY_COMMAND 14:03:56 [NLGBS01] Admin */
RODDPEST=ALL;
EXTERNAL DESTINATION ROUTE DATA


DEST DRN ROU CHO CUST ADC TRC SRT NUMACK PRE


0 1 0005000000000250000000000 0 2 0
1 1 0005000000000250000000000 0 2 0
2 1 1 0005000000000250000000000 0 2 0
1 2 0005000000000250000000000 0 2 0


END

 

[LME]

Hi
Change SIG on route to 111100000030 and see if that works you can always change it back to 511100000030 .