Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

External Caller ID question for CS1000 Analog Sets 2

Status
Not open for further replies.

chrisbesaw

Technical User
Jul 3, 2012
4
US
Hello,

I was wondering if its possible to enable external caller ID on a analog set? The caller ID work inside the district but outside numbers do not. I posted below the TN config. Any help would be greatly appreciated.
Thank you




TYPE TNB
TN 252 0 3 2
SPWD
DATE
PAGE
DES

DES EJD
TN 252 0 03 02 PHANTOM
TYPE 500
CDEN 4D
CUST 0
MRT
ERL 00030
WRLS NO
DN 6951551 0 MARP
CPND
NAME PCSD BUS GARAGE
XPLN 24
DISPLAY_FMT FIRST,LAST
AST NO
IAPG 0
HUNT
TGAR 1
LDN NO
NCOS 0
SGRP 0
RNPG 0
XLST 0
SCI 0
CLS CTD DTN FBD XFD WTA THFD FND HTD ONS
LPR XRD AGRD CWD SWD MWD RMMD LPD XHD SLKD CCSD LND TVD
CFTD SFD MRD C6D CNIA CLBD AUTU
ICDD CDMD LLCN EHTD MCTD
GPUD DPUD CFXD ARHD OVDD AGTD CLTD LDTD ASCD SDND
MBXD CPFA CPTA DDGA NAMA MIND
MCRD
EXR0 SHL ABDD CFHD DNDY DNO3
CWND USMD USRD BNRD OCBD RTDD RBDD RBHD FAXD CNUD CNAD PGND FTTC
CDMR PRED MCDD T87D SBMD PKCH MPTD ELCD
PLEV 02
PUID
UPWD
AACS NO
MLWU_LANG 0
FTR DCFW 8 1377000
DATE 27 SEP 2013
 
The TN you posted is a phantom TN. It cannot originate calls and does receive calls directly.

If you want to see the CLID of incoming external calls then that feature needs to be enabled on the trunks for a start.
Do you see the CLID on non-analog phones?
 
The method that transmits the CLID information is called CLASS (don't remember the breakdown of the acronym). It has its own section in the Features and Services guide. Few people know how to implement it so you really need to want it bad to go forward. I would move the user to a 3901, 1110, etc before I would try to go down the CLASS direction.

 
Analog caller-id also requires an additional CLASS Modem card in the switch (Shared resource), and special class licenses (instead of an analog license, you have a CLASS license instead (in ld 10 - I show Analog Phones and Class Phones)
In the older releases, the licenses were separate; I'm not sure how it works since the addition of IP licenses. Maybe all the older phones were one license, and IP phones are separate now? Since I'm still back on 4.5 I don't know for sure....
30n30w
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top