Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations Rhinorhino on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
Ext ringing main att even when unplugged, every 15min
- Thread starter x300
- Start date
I need more info:
1. Does this slt (analog phone) have a DDI (or DID) number
(Direct number)?
2. Has any other phone a hot line to the slt phone?
3. Setup some SMDR (Station Message Detailed Recording).
This can be done at almost no cost. Make the SMDR
printout go from the serial or LANU port to a PC, in a
safe place. Now you can see from which phone the call
comes.
4. Are some PC applications connected like ez Phone or ez
Attendant. These could have a build-in times dialler.
5. Check also any dial-in line, where you get a new dial
tone (DISA line).
Most important of all (belive me!) is the SMDR. We had similiar cases, and found of that a former employee harrassed his/her old work place, by this.
The "fraud" or sabotage was done through a DISA line.
Let me know about your progress.
///doktor
1. Does this slt (analog phone) have a DDI (or DID) number
(Direct number)?
2. Has any other phone a hot line to the slt phone?
3. Setup some SMDR (Station Message Detailed Recording).
This can be done at almost no cost. Make the SMDR
printout go from the serial or LANU port to a PC, in a
safe place. Now you can see from which phone the call
comes.
4. Are some PC applications connected like ez Phone or ez
Attendant. These could have a build-in times dialler.
5. Check also any dial-in line, where you get a new dial
tone (DISA line).
Most important of all (belive me!) is the SMDR. We had similiar cases, and found of that a former employee harrassed his/her old work place, by this.
The "fraud" or sabotage was done through a DISA line.
Let me know about your progress.
///doktor
- Thread starter
- #3
With the hotel version there was a feature, that we were looking through, but we did not use it. It was the bath alarm. Can it be timed?
Do you have some relays or contacts that can be activated and give you this alarm?
I have 2 scenarios that could solve this issue:
1.
Remowe all cabling except the 2 wires for the attendant console (or where you receive these alarms).
2.
Remowe all database, and re-program the PBX.
Remember to initialize in PGM 450 before re-progeramming it.
Re-programming should be done maually, if you use the back-up, then the fault will appear again.
Let me hear about your progrss
///doktor
Do you have some relays or contacts that can be activated and give you this alarm?
I have 2 scenarios that could solve this issue:
1.
Remowe all cabling except the 2 wires for the attendant console (or where you receive these alarms).
2.
Remowe all database, and re-program the PBX.
Remember to initialize in PGM 450 before re-progeramming it.
Re-programming should be done maually, if you use the back-up, then the fault will appear again.
Let me hear about your progrss
///doktor
- Status
Similar threads
- Locked
- Question