Did you buy the Arcserve Agent for Exchange Server?
If not, you need that.
AND it is not just an install, there is quite a bit of setup. Glenn A
"Do not meddle in the affairs of dragons, for you are tasty and crunchy and good with ketchup."
Earlier I tried to build a restore-server using the old version ArcServe and didn't have any success. I managed the restore but Exchange-services couldn't be started afterwars.
I hav heard that it should be possible with the new ArcServe2000.
Did you create the user dbagent in NT and in Exchange?
Did you send it email to initialize?
Did you give it the access rights it needs other than administrator?
Did you give it the policy rights it needs?
When you backup or restore are you logging in to the Arcserve/Exchange Agent as dbagent? Glenn A
"Do not meddle in the affairs of dragons, for you are tasty and crunchy and good with ketchup."
In my first attempt i created a restore-network as a clone of my domain. (BDC on separate network promoted to PDC.)
I added my restore-server to the restore-network and moved my backup-server from the production network to the restore-network.
Exchange was installed on a server with same servermane, org and site as the production server. I used the same accounts as originally used in the production domain.
Exchange was set up to use the same paths for databases and logs.
ARCserve backupclient was installed using same account as in the production network.
Restore database succeded but Exchange-services didn't start.
When you backup, do you see the Brick Level Option? Glenn A
"Do not meddle in the affairs of dragons, for you are tasty and crunchy and good with ketchup."
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.