My Exchange 5.5 server will not send or receive external e-mail only internal. The only that has changed has been the addition of SMTP to this server. Help me please!!!!!!!!!!
I have looked at the MS Mail Connector services in Exchange and I have noticed that it is not working. I am useing Backup Exec 8.5 with Exchange Agent installed, now this is just a thought what if I restore exchange from my last full back up. Will this destroy or modify data base stores or will I need to restore these stores also?
Another thing to check is your DNS entry's. If your Exchange is not in your DNS then it would not receive mail.
If you do a full restore then you will loose all data since the last backup. Unless you can do a specific restore. Before you try the restore do another full backup.
I would suggest that you correct your settings on your connector. Hope this Helps
I have tryed to correct my connector settings but it gives me an error, the error is failure to load MS extention. I am now trying to do a full restore from tape then restore the stores from my full backup today.
I also run Exch 5.5 with a firewall. (Symantec) Is it more effective to point the Exch server's gateway to the firewall as opposed to the same gateway that all the workstations/servers are pointing to? At the moment, all the workstations point to a router (172.29.180.8) and the exchange server points to the firewall (172.29.180.10). Recently I had changed this and pointed the Exch server to the same gateway as the other systems....every now and then I would get an undeliverable message (communications failure blah blah). It would then send on the next try. I have since changed to back to pointing to the firewall.
Any ideas why this would happen - sounds like a DNS problem...even though our exchange server is the primary DNS server and the gatway the 2ndary!
I presume that you have made sure that you are running the IMS service and that it has started correctly. The Internet mail Service is needed to send and receive mail from external as far as i know. If this servce is stopped, you will not be able tosend/rec from external.
Perhaps you could try deleting the IMS and re-adding it again.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.