eval [exc] does not work

[tcluser16]

Hi,

I am trying to executing perl script from tcl.Here are three commands.The varaibles are in the tcl script itself.mY first command works but not other 2.Do I need to do something else.

eval [exec bsub -Ip -R "type=SPARC" -cwd /usr2/STATUS '/usr2/j/local/bin/perl5.6.1 /usr2/j/CAM_STATUS/auto_submit $c $T $E $review $Error $Reset $Analysis_Error $DFTDSM_Analysis_Error $LP_Analysis_Error']




eval [exec bsub -Ip -R "type=SPARC" -cwd /usr2/STATUS '/usr2/j/local/bin/perl5.6.1 /usr2/j/CAM_STATUS/auto_pldrc_submit $c $T $W $Lint_Review_warning $Lint_Must_warning $Lint_Reset_warning $DFT_Analysis_warning $DFTDSM_Analysis_warning $LP_Analysis_warning']

eval [exec bsub -Ip -R "type=SPARC" -cwd /usr2/SsATUS '/usr2/j/local/bin/perl5.6.1 /usr2/j/CAM_STATUS/auto_pldrc_submit $chip $TOP $runtime $run_time_lint_Review $run_time_lint_must $run_time_Lint_Reset $run_time_DFT_Analysis $run_time_DFTDSM_Analysis $run_time_LP_Analysis']

 

[Bong]

Are you expecting any connection from one command to the next? That is, if you're thinking the Perl execution will update variables to be used in the next Perl execution, you'll be disappointed.

_________________
Bob Rashkin

 

[tcluser16]

Hi,
These 3 command are independent of each other

 

[tcluser16]

Hi,

As a experiment ,I tried puts command after first eval command,It does not print that,so prompt does not come back after first eval.Any suggestions?

eval [exec bsub -Ip -R "type=SPARC" -cwd /usr2/STATUS '/usr2/j/local/bin/perl5.6.1 /usr2/j/CAM_STATUS/auto_submit $c $T $E $review $Error $Reset $Analysis_Error $DFTDSM_Analysis_Error $LP_Analysis_Error']

puts "Error added

 

[Bong]

Why are you using "eval"? That is, go ahead and try just "exec"ing the commands.

_________________
Bob Rashkin