Euro ISDN to a Aculab card

[foleys]

Has anybody had any dealings with connecting a Euro ISDN to a Aculab card. We have a new conference bridge being installed and it has a Aculab ISDN card. The installers have said they have programmed it as Euro Etsi. We have done to same as them but we are having problems synching up.

Any help will be greatly appreciated.

Regards

Sean

 

[mikeyb123]

yes I've used these. Make sure the meridian is the master end of the link ie side = net (in the dch config)

check the clocking source on the aculab card is set to look to the meridian.



It's not getting any smarter out there. You have to come to terms with stupidity, and make it work for you.

 

[mikeyb123]

what aculab card are you using?

It's not getting any smarter out there. You have to come to terms with stupidity, and make it work for you.

 

[foleys]

Mikeyb123

Thank you for your quick reply. The card is 2 Port Prosody PCI DAC card

Thanks

Sean

 

[mikeyb123]

we also loaded ets300 on the aculab card for the protocol I can't remember what switches we used but I'll check.

It's not getting any smarter out there. You have to come to terms with stupidity, and make it work for you.

 

[foleys]

Mikeyb123

It's ok we change the Meridian to ESGF Net and changed the Aculab to qsig with Non crc4 and slave A.

It's now all working

Thank you very much

Sean