Establish trunk for analog paging 1

[TIgerV]

I have a TMANI card at 1-2-14.
I would like to create an analog paging trunk at 1-2-14-8.
My ultimate goal is I would like to dial either an extension or trunk access code that will allow me to pass analog voice over the channel.
I don't need any special tones or signaling, just analog voice from the dialing handset through the port. Disconnect on hangup.
Can anyone help me out on the AMO to create such an animal?

--TIger

 

[TIgerV]

Sorry, Unify Hipath 4000v6

--TIger

 

[sbcsu]

Is the paging system expecting to see an extension or a trunk from the HiPath ?

 

[TIgerV]

Trunk. All it wants is voice.

--TIger

 

[sbcsu]

Set up the analogue trunk.
Set it up the same way as an 'ordinary analogue trunk'
But then look at the COP/COT and make changes there.

Add your access code in WABE as TIE
BUEND
RICHT
LODR
LDAT
LDPLN

 

[MerlinJ]

sbcsu, would you mind breaking down setting up an 'ordinary analogue trunk' a little more. I am hopelessly bad with the trunk portion of my V6.

I've actually been needing this information as I have several older type paging systems with no adapters/intermediate boxes that used to just get a voice trunk from my ROLM 9751. The installers told me there was no way to get those to work with the V6 as it couldn't do just pure voice trunks. I had to jury-rig the systems to other paging systems to get them to work.

 

[sbcsu]

Hi MerlinJ
The V6 will do voice trunks, analogue and digital.
What analogue trunk cards do you have fitted in the V6 ?