Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
Error: "there has been a signature failure" 4
- Thread starter ajlueth
- Start date
-
3
- #21
And the answer is!
Drum roll please!
FDISK /MBR at a dos prompt.
Ghost the drive, then DO NOT reset the computer when Ghost is done. Instead exit Ghost. Now depending if you have a floppy boot disk or a CDRW B-Disk make sure it has fdisk on it and then run fdisk /mbr. NEXT type in Fdisk again without the /mbr and make sure the acitve partition is not set to boot up the service drive. Make sure its set on the 33gig partition.
Follow steps in this order and your IBM T42 stinkpads should be just fine.
Been there done that!
Drum roll please!
FDISK /MBR at a dos prompt.
Ghost the drive, then DO NOT reset the computer when Ghost is done. Instead exit Ghost. Now depending if you have a floppy boot disk or a CDRW B-Disk make sure it has fdisk on it and then run fdisk /mbr. NEXT type in Fdisk again without the /mbr and make sure the acitve partition is not set to boot up the service drive. Make sure its set on the 33gig partition.
Follow steps in this order and your IBM T42 stinkpads should be just fine.
Been there done that!
- Status
Similar threads
- Locked
- Question
- Locked
- Question
- Locked
- Question
- Locked
- Question