Use the command "clear errors". This will clear the error log. You may also use the test command with clear appended to the end. For example, If you receive an error on Trunk 1 member 36 you could enter the command "test trunk 1/36 long clear". This should resolve any errors and remove the entry from the Alarm Log.
I probably should have included this earlier...I'm using ver 6 and it doesn't appear that I can add alarm or error to the clear command. Just AMW, Events, measurements & port...
So the question should be how do I clear the error & alarm log warnings in a V6 switch?
I think that you dont have the right to do that.
Could you please look at your service level and your permissions first.
"disp login XXXX" (XXXX = your login ID)
If you cant do this comand try than "list login"
and "display permissions XXXX"
(XXXX = your login ID)
Check the permissions so that you know what you can do.
that should be the reason that you dont see all the commands
check your permissions and look for the maintenance commands. At least you'll need maintain stations, trunks andsystem[/].
Anything else? Let me know!
Kind Regards,
Maarten Copini
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.