I've just upgraded a Rls 3.0 Opt61 to Rls 6. The ITG card was replaced with a sig_server/MC32s card. I programmed the IP trunks as IPTI. Now, I get a err648 (No TN for ITG card) on both inbound and outbound calls on this route. Anyone know what causes this? I've got all the patches in the CPIV card and sig server. The MC32s firmware is what came with card. I didn't have any patches for it.
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
err648 on release 6 upgrade
- Thread starter hwking
- Start date
If you do a Search on "err648" a number of other posters reported that there is a patch for this. Although you said you had them all, I suspect there is another one out there.
--
Nortel Resources at GHTROUT.com
--
--
Nortel Resources at GHTROUT.com
--
- Thread starter
- #3
You only have one MG32s card and it is programmed as IPTI trunks?
the MG32s card ports should be programmed as VGW ports - this will provode the DSPs to convert IP to TDM.
Not sure I read your post correctly - if not, post the following:
LD 117
stat serv
the MG32s card ports should be programmed as VGW ports - this will provode the DSPs to convert IP to TDM.
Not sure I read your post correctly - if not, post the following:
LD 117
stat serv
- Status
Similar threads
- Locked
- Question
- Locked
- Question
