Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Err5142, No route 14 exist

Status
Not open for further replies.

kondalisa

MIS
Dec 21, 2008
75
Hi, It is CS1000/81c, CPPIV, Release 5.5. I am getting the following error after every 4 or 5 minutes

ERR5142 00000000 00000014


>err err5142
>

ERR5142 x y
Required Configurations for TRO-CM to work is missing.
Check TRO( Overlay 16) and/or VTRO ( overlay 17) prompts.
Where: X is the customer number.
Y is the route number.
Enable TRO and/or VTRO.
Severity: Minor


There is no route 14 configured in this PBX, any help??


 
Do you have a virtual route though??

ISDN YES
MODE ISLD
DCH 7
IFC SL1
PNI 00001
NCNA YES
NCRD YES *******
TRO NO *******
FALT NO
CTYP UKWN
INAC NO
ISAR NO
DAPC NO

Mato' Was'aka
 
Hi BI. yes there is one virtual route configure but it route number is different. I will see if TRO is set to YES of this route...What exactly does TRO/VTRO use for??? do i turn off TRO in my route if it is set to yes? wouldnt that effect any thing?
Take cares
 
I honestly can't remember, but use to get that on 3.0 and I believe I did make a chg just so I would get that TRO error. I do not think it effected anything.

Mato' Was'aka
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top