Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations TouchToneTommy on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Erasure of a LIM

Status
Not open for further replies.

adminpabx

Technical User
Dec 29, 2010
15
MG
I followed all the steps mentioned in Alex to remove last LIM 26. When I sent command GJLIE, it says <gjlie:gsmult=0-13;
NOT ACCEPTED
LAST PCM-LINK
<gjlsp:gsmult=0-13,print=all; GROUP JUNCTOR LINE STATUS
EQU = 26-0-00-0 GS-MULT 0-13
GS SIDE 0 ACTIVE ACTIVATED SIGNALLING SYNC RECEIVING
SIDE 0 ALARM 0000 0000 0000 0000 GSMINPUT 11111100


Any Help ?
 
I don't think you have to remove the link!
"Remove all PCM-lines except the signalling line"
Now you have to remove the lim by CNLIE:...
and then SFCEI;

 
Adminpabx, I think what you are wanting to do is end LIM26?

This is quite an involved procedure and you may need the help of your system maintainer to help you cease/end the programming in the group switch otherwise you will have alarms for LIM26 etc!

Couldn't you just move LIM26 to another site and leave it running?
This would give you the flexibility to re-deploy it later at another site should you need to.

By keeping LIM26 running it gives you options to adjust your network????
 
Follow this steps:
1)BLLTI:LIM=26;
2)Remove all PCM-lines except the signalling line.
3)CNLIE:LIM=26;
4)SFCEI;
Bye
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top