I have an insert that has 6 columns of type. It contains a table that is so deep it takes up 3 columns. The table did not break at a good spot so I put in an "end of column" (the "enter" key to right of keypad). Now the client has added 4 more lines to the table and, of course, the column break I made no longer works. I need to adjust for these 4 extra lines. I need to remove the "end of column" ... but I can't find it! I've tried putting the cursor at the start of the table and using the "forward delete" key but instead of removing the "end of column", the whole table disappears. If I move the cursor to the end of the table and use the "backward delete" key the table disappears again. I have tried moving the table onto the pasteboard and marrying up all 3 columns into 1 continuous long column but that "end of column" is still there. I have tried using "find/change" for "column break" and also just searching for the carat character but nothing is found. How do I remove that "end of column"???