rlevasseur
Programmer
I have just completed upgrading a large application to remove the old .ocx Crystal viewer control with the new crviewer.dll using RDC. I got it to finally work (sorta), but users would like to have the printer selection icon enabled.
As it stands now, the reports will go to the printer defined in the Crystal report, or if the user does not have that printer in their defined printers, it defaults to their default printer. In many cases the report "must" go to a selected printer. I also noticed that even though I enable the close button on the viewer, it remains grayed out
I hope there's a simple selection for this.
Thanks Ray
As it stands now, the reports will go to the printer defined in the Crystal report, or if the user does not have that printer in their defined printers, it defaults to their default printer. In many cases the report "must" go to a selected printer. I also noticed that even though I enable the close button on the viewer, it remains grayed out
I hope there's a simple selection for this.
Thanks Ray