Enabling ethernet port on Realitis 7.1 1

[steve942]

Can anyone help me to enable the ethernet ports on a Realitis DX150R running 7.1 S/W

 

[g6udx]

Siemens usually ship a system with an address of 88.0.0.1. This can be change with the SETENV command within ASMI.

 

[iSDX]

Use command asmi from the maintenace terminal, port 1.
Type se to list the environment variables, type se.
To change the ip address of the ethernet port

se ipact= ....deletes
se ipact=192.168.255.xxx ...assigns

Note a reboot of the system in required for changes to take effect.

If subnet addressing is required a route must be added.

se route1=

ROUTEx=44.0.0.0,88.0.0.1,N,255.0.0.0

Format: <destination IP address>,<router IP address>, <type>,<subnet mask address>

type= N for network
type= H for host

Telenet ports are as follows

MMI ports
customer = 23
remote = 19826
maintence = 19821

Setting up NIVAL @ 6.2 S/w to secure the ethernet connections a client database can be set by the following.

1.Log in via the V.24 maintenance port.
2.LPAT 42140, do not proceed if this patch is not installed.
3. Use the command ASMI to access the system maintenance interface (SMI)
4.Use the command DIR to check that NI.dat does not exist, if it does, delete the file.
5.Now set NIVAL in the environment (On both UPI’s if a DUAL system)
L System: SE NIVAL=1.0/NI.dat
SN and Micro System: SE NIVAL=0.0/NI.dat
5.Exit SMI> ; Type “E”
6.Now reset the UPI in order for change to take effect.
7.After the system reloads, at maintenance port use the command ANIC to set clients after logging back in.
ANIC FTP xxx.xxx.xxx.xxx
ANIC FTP 192.168.155.1
ANIC FTPUSER bla blabla
etc
8.Re-enter ASMI and confirm that NI.dat has been created, by using DIR at the SMI> prompt. Exit SMI>