ELECTRA ELITE IPK 3

[flori1]

i'M 20 years Nortel,But brand new to NEC,so here goes:my customer has a elite ipk with 2 sta. cards and one co card,
I will be adding a PRI to the system real soon, he has purchased a DT1-430 card,doesn't the cpu need a clocking card on it?what mb are required 1-1-20,1-1-21,1-1-22 and 23
where can i get tech support for the cut-over?
thanks in advance

 

[ctvi]

Which IPK is it? IPKI or IPKII? You need a clocking card. Where are you located. Need more info on what protocols i.e. NI2 etc and how many channels.

Here are some part numbers you will need: 750112 - PKU 192-2U to allow more than 48 ports and 750130 a clocking card.

Welcome to NEC. It is nicer to program than the Nortel where you always get lost on a submenu or a main menu tree. This has only 2 menu tree. You have been doing the ICS, I guess.

http://www.ctvi.com

 

[Drue]

Here is a procedure I made up a while ago hopefully this will help


PROCEDURES TO INSTALL A PRI T-1 ON AN NEC ELITE

1. Install Clock Card on CPU (Set SW1 to ISDN.PHS)
2. Install PRI T-1 Card in Cabinet 1 Slot 4 (SEE NOTE 1) and set Switch 1 to match the PRI T-1 provider protocol (usually NI2)
3. 1-8-33 Master Clock Selection- Cabinet 1 Slot 4 (Cabinet and Slot of PRI T-1 Card)
4. 1-13-00 PRT Channel Assignment- LK7 (24)
5. 1-13-01 PRT Signal Format Selection- LK2 (24 ESF)
6. 1-13-02 Clear Channel Selection- LK2 (B8ZS)
7. 3-03 Trunk to Trunk Group Assignment- Set Channels 1 to 23 of PRI T-1 to Route 10
8. 3-03 Trunk to Trunk Group Assignment- Set Channel 24 to Route 11
9. 3-04 Trunk to Trunk Transfer Yes/No Selection- Set Channels 1 to 23 of PRI T-1 to YES (LK2)
10. 3-91 Trunk Type- Set Channels 1 to 23 of T-1 to DID (LK4)
11. 3-91 Trunk Type- Set Channel 24 of T-1 to CO (LK1)
12. 1-1-20 DID Length Selection- If needed
13. 1-1-21 DID Digit Conversion Assignment- If needed
14. 1-1-22 DID Digit Conversion Table- If needed
15. 1-1-23 Forward Station Number for Busy Station or Undefined Digit- If needed (usually pilot number to voice mail)

NOTE 1: System can handle a max of 3 PRI T-1 Cards (Cabinet 1 Slot 1, Cabinet 1 Slot 4 or Cabinet 2 Slot 1)

 

[gbaughma]

Drue:

Ooooh... that needs to be a FAQ... please do so. Good stuff. Have a Star.



Just my 2¢
-Cole's Law: Shredded cabbage

--Greg

http://parallel.tzo.com

 

[rotters]

There are some other caveates about where to put the ISDN card. In the earlier versions of the Elite, it takes up 3 slots!!!