Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations strongm on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Electra Elite 192 telco programming

Status
Not open for further replies.

hplight

Technical User
May 13, 2010
2
US
(Having to pick up supporting an old system)
How do I change which incoming telco lines are active (since they went ahead and disconnected 6 of them already...)
 
That is sort of a general question. could you be more specific about what it is you want them to do or not do?

"However beautiful the strategy, you should occasionally look at the results." Sir Winston Churchill
 
Sorry about the general question...

The company had 12 incoming lines (in two rollover groups). They disconnected the last few lines in each group to save phone costs. Unfortunately, the outgoing line selection started from the END of the group so attempts to get an outgoing line got dead service.

After painfully trying to make sense of of the IPK programming book, I eventually got to the right place.

This was the "Trunk (Installed, DP/DTMF) Selection". After some more trial and error, I eventually was able to set the disconnected lines to NIL. This resolved the problem.

I got the NEC manual from
which allowed me to get this far.

Thanks
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top