Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

E2T packet loss

Status
Not open for further replies.

msrohnan824

Technical User
Dec 13, 2004
5
US

Hi,

There is a customer with a new 3300 a(7.1.3.4) ICP at a site It has been in production for a few weeks. It is experiencing a lot packet loss on the E2T card. The allocated Cisco switchport shows no errors and the bandwidth is plenty avaiable for calls.

Has anyone else had this problem?

E2T stats:

-> e2tShow 1
e2tShow 1

E2tConfig.FirstTdmChannel: 0
E2tConfig.LastTdmChannel : 127

-------------------------------- E2T Stats ---
TUE SEP 04 18:02:25 2007


Mitel Dynamic Jitter Buffer
RTC 10.67.128.16
TDM codec is U_LAW_CODEC -- North America
Total Calls Setup 2110
E2T crypto/clear Ch. currently active 0/0 (high 0/9)
DSP Transcoders currently active 0 (high 7)
Local Transcoders currently active 0 (high 0)
Pass: UDP port not in voice range 871
Info: Ch with multiple src addresses 0
Pass: ICMP_ECHOREQUEST 1073
Pass: ICMP_REDIRECT 0
Pass: ICMP_UNREACH 0
Drop: ICMP_UNREACH_PORT UDP 0
Pass: ICMP_ECHOREPLY 34
Pass: ICMP_SRC_QUENCH 0
Pass: icmp_other 0
Drop: Invalid DTMF digit 0
Drop: Rx UDP audio on Closed Ch 841
Drop: wrong g711 codec 1619
Drop: codec not g729 2204
Drop: codec g729 bad length 0
Drop: codec g711 bad length 29
Calls with Jitter > 300ms 0
Calls with Packet Loss > 2% 1517
RTP Sequence errors 23429
RTP Seq total missing pkts 188360
RTP Seq Packets out of order 1
Host dst mod by icmp redirect 0
DTMF RTP Pkts Rx 8
DTMF digits received 1
DTMF no inter digit gap 0
DTMF added pkts for min len 0
DTMF overflow 0
DTMF Duplicate E=1 0
DTMF Digits without E=1 flag 0
DTMF pkts digit starve 0
zFree Errors 0
VQ Stats msgs dropped 0
EOS Detection (Active\Req\Reports\Det) 0\0\0\0
EOS event table overflow count 0
aggregate EED counters:
eedInitiated 2074
eedSuccessful 1804
eedAbandoned 270
eedFailed 0
eedDecryptErrorMustWaitForModify 0
eedUnknownPtWaitForModify 0
eedDataCallWaitForModify 0
eedDtfmWaitForModify 0
eedMustWaitForModify 0
eedControlFsmStateMismatch 0
eedVoiceFsmStateMismatch 0
decryptError 0
encryptError 0
invalidE2tContext 0





For starters, I'm replacing the network cable tomorrow.

Thanks in advance,

M
 
Hi,

Wich type of trunking is used at this side?

E1/T1 or SIP or Analog?

Because the E2T-card is only used for conversion between IP and Non-IP end-points
 
Thanks for the response.

XNET IP trunking between sites and the CO. There are two PRIs using digital trunking.

G.729 (compression) is used between the IP sites.


-Mike
 
Do you have QoS enabled between sites? Do you have Voice quality statistics enabled on 3300?
This can help you to pinpoint the problem.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top