Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations strongm on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

E1 / T1 Conf.

Status
Not open for further replies.

telpozo

IS-IT--Management
May 5, 2014
219
Hello,i have to set up a Pri Trunk E1 on IPO 500 V2,the system with the Trunk daugther card
has already 8 channels, and 22 licenses is installed for that feature,in total 30 channels,
correct ! but i got confused on the manager,between Pri 24 T1 and Pri 30 E1 what will best ??
(I heard about that the E1 "Europe" and T1 for the North America...) But i have done it
on E1 conf. For 30 channels that allows 30 simultaneous call,all incoming call will be routed through the IPO,also in the Incoming Number field (Inccoming Number) some individual lines has been set that the callers
will be use,and will be use for out going call. The problem is that only these line that have been set in the incoming number field
work,all the rest are blocked.

Thanks.
 
Sorry !
I was doing all quickly,but i want to tell you,For a Pri trunk E1, i set an incoming call route for these different lines through the IPO,unfortunately i missed a lot of things on that configuration for the reason that only the numbers (Lines) that has been fixed on the IPO (Incoming / Outgoing call) works, all the rests are blocked.
The problem is that i configured some lines as an direct lines that the callers will use .
Thanks.
 
I suggest you call in a competent maintainer as you clearly have no Idea how calls are presented on an E1 circuit.


A Maintenance contract is essential, not a Luxury.
Do things on the cheap & it will cost you dear
 
Must be some kind of jungle E1R2 interface, 30 analogs squeezed into a PRI converter?
Never seen anyone write this much (nonsense) about a feature so straight forward as an E1 getting calls in and out.

Kind regards

Gunnar
______________________________________
Mille viae ducunt homines per saecula Romam

2cnvimggcac8ua2fg.jpg
 
how can have dedicated channel on e1 ???
i'm thinking this
line > channel , you can change the group id (in/out)
 
Ok,Sorry everybody for my misunderstanding for that feature or for all... but with the PRI trunk E1, i'm looking on how to route a part of numbers on an certain extensions while some are reserved to other particular extensions but every user can make outgoing call using.
Thanks,
Other suggetions.
 
Are your trying to get some DDI's pointing to a different extn than it would normally hit?
555-1234 normally goes to extn 1234, but you want it at extn 1222

Or

Do you want a group of DDI's to go to a specific extn?
555-123X all going to extn 1239

Use ICR for this: Enter the DDI(s) in Incoming number and set the Destination you want.
(X is wildcard in the incoming number)

Kind regards

Gunnar
______________________________________
Mille viae ducunt homines per saecula Romam

2cnvimggcac8ua2fg.jpg
 
Training!

Take Care

Matt
I have always wished that my computer would be as easy to use as my telephone.
My wish has come true. I no longer know how to use my telephone.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top