Dual CLI output on MD110

[cv8devil]

I presently look after a number of MD110 sites and have been asked to investigate sending correct CLI on a few of these sites BC10 and BC11). All sites have a private network route where CLI is allowed and public ISDN route where CLI is blocked. The question is where I have multiple number ranges, at present the calls over the private network are sending one prefix as part of the CLI and I need to send a different prefix depending on what extension range is making the call. Can this be done.

 

[whosrdaddy]

yes this can be done via NUTRI (cnvtyp = 1, numtyp 10 for public, numtyp 11 for private)
ADC bit must be set for this to work

-----------------------------------------------------
What You See Is What You Get
Never underestimate tha powah of tha google!

 

[cv8devil]

OK thanks for that. If I have number range 6126xxxx and 6266xxxx both in the same PABX (feeding different extensions obviously) the CLI being sent for both ranges is 6126xxxx, so half of the extensions are sending the wrong prefix.

 

[whosrdaddy]

ok, suppose you have a range

61261000-62611999
and
62662000-62662999

nutri:entry=1,cnvtyp=1,numtyp=10,pre=6126;
nutri:entry=2,cnvtyp=1,numtyp=10,pre=6266;

make sure you don't have RONDI entries for the routes

-----------------------------------------------------
What You See Is What You Get
Never underestimate tha powah of tha google!

 

[cv8devil]

Thankyou for that. It's a bit hard being the lead on MD's for this client without having any locally to me