DTI2 E1 R2

[simplyme]

Im having trouble on having a DTI 2mb running on R2 signalling to go to level 2 or produce a B5 (call to a vacant/non existing number) signal to the originating end. The call is incoming. The E1 is set as a Tie with bit signals set for E&M , bothways on the route data block. Outgoing and incoming calls are terminated and completed with normal R2 signals. It is just on the vacant number that the PBX produces A4 cogestion or Fail signal when it detects the number does not exist in the system. Does anybody have a similar experience?

Thanks in advance.

 

[simplyme]

Anybody with any idea on this?

 

[Capipo]

Set bit signals in E&M with R2?? are you sure? Don't Care

Check in LD 94
REQ PRT
Type R2MF
ICOG OGT --> Outgoing table
TBNO 0 --> The table number used in Route (ld 16)
...

Look at level 2 (LVNO 2) Received signals

RECV 2 OUTT
3 BUSY
4 CONG
5 VACC --> SET THIS IN YOUR SYSTEM
6 IDLE
7 IDLE
8 OUTT
9 FAIL

Try this.

Capipo.

 

[mabsar]

can you post the ABCD bit signalling? what model of router you are connecting with DTI?

 

[mabsar]

can you post the ABCD bit pattern? what model of router you are using for this connectivity?