Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

DS1 Signaling in G3si R7

Status
Not open for further replies.
gcrjeff

gcrjeff

IS-IT--Management
Sep 27, 2006
1
US
I need to change the ds1 signaling on my G3si from Common-chan to CAS. When I try, I get an error "cannot change while port installed". Any ideas how to accomplish this?
 
Sort by date Sort by votes
You will probably need to remove all of the translations associated with the board. Even with busying the board out you run the risk of software corruption.

Kevin
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

Stinney
  • Question
Can't set SIP signaling group to not add '+' 1
Replies
2
Views
5K
Instructor of Avaya
Instructor of Avaya
bankingguy
  • Locked
  • Question
Egypt sample DS1 board configuration (Telecom Egypt)
Replies
1
Views
115
ZeroZeroOne
ZeroZeroOne
malek taha
  • Locked
  • Question
CM/SIP trunk signaling with provider
Replies
0
Views
601
malek taha
malek taha
chiefredjim
  • Locked
  • Question
Definity G3SI Ver 11 Transfer call busy signal
Replies
2
Views
127
chiefredjim
chiefredjim
LineMann
  • Locked
  • Question
Help needed with Avaya definity g3 si ds1 country protocol
Replies
3
Views
118
biglebowski
biglebowski

Part and Inventory Search

Sponsor

Back
Top