DS1 settings for PRI in Ireland 1

[Nick44]

Hi,
This is an MM710 DS1 pack in a G430 gateway.

If I configure up the DS1 for standard etsi working the circuit does not function properly.
If set to country code 10, with busy/idle bits set to all the 1's the circuit comes in, but suffers from intermittent call drop.

I understand that Irish PRI is "on demand" rather than the usual always on in the UK or other standard etsi presentation.

Has anyone got a model DS1 setup that is known good for Irish PRI, or any other suggestions please?

many Thanks,
Nick.

Speak softly and carry a big switch

 

[Speewah]

Working config from an MM710 DS1 in a G450 in Ireland..


DS1 CIRCUIT PACK

Location: **** Name: ****
Bit Rate: 2.048 Line Coding: hdb3

Signaling Mode: isdn-pri
Connect: network
TN-C7 Long Timers? n Country Protocol: 10
Interworking Message: ALERTing Protocol Version: b
Interface Companding: alaw CRC? y
Idle Code: 01010100
DCP/Analog Bearer Capability: 3.1kHz

T303 Timer(sec): 4


Slip Detection? y Near-end CSU Type: other

Echo Cancellation? n

 

[wpetilli]

my site is setup with

bit rate: 2.048 hdb3
signaling: isdn-pri
alaw
01010100

country protocol: etsi
near end csu type: other

 

[Nick44]

Thanks for your helpful post

Speak softly and carry a big switch