DS! Programming Help 1

[SSgt]

I am new to trunk programming. I installed a new DS-1 Circuit pack into my G3R. List config reveals the new circuit pack, but when I creat a new trunk and add the first channel in the group member assignments I am told ""03B1801" Must use administered DS1 or UDS1 circuit pack. Any suggestions?

Thanks

 

[CableMonkey]

Did you "add ds1 xxxxx"? You will need to add the signaling group also.

 

[1a22ip]

You will only need a signal group if the trunk is ISDN.

ED

1a2 to ip I seen it all

 

[SSgt]

Thanks CableMonkey...it's up now. I am using this trunk to connect to a Polycom VS 4000 VTC unit. Any ideas on how to associated a DID number to my trunk so the VTC may receive call requests?


Thanks