Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations John Tel on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

driver problems

Status
Not open for further replies.

jesse83189

Technical User
Feb 3, 2007
78
US
when i switched my old hard drive out for better one from a suckier computer....it doesnt recognize any of the things that are already installed...it dont recognize the PCI ethernet card which is what i need to install my internet.....any suggestions?
 
plug in old hard drive as a slave drive, have your current drive scan the old one for drivers. Have it check system32, drivercache and places of that nature.

Or you can use a friends computer, look up your network card on the manufacturers site and get the driver there.



There is a point in wisdom and knowledge that when you reach it, you exceed what is considered possible - Jason Schoon
 
In safe mode you could run regedit and delete the enum key in HKLM. This would force a new scan and attachment of hardware.
It may ask for a driver disk or cd that goes with the card or motherboard. Depends on whether it needed it on the original install on the old drive.

Ed Fair
Give the wrong symptoms, get the wrong solutions.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top