Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations strongm on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

DOD problem

Status
Not open for further replies.

lapakhora

MIS
Jan 18, 2012
294
PK
Gi all, We have a DID pri working at CS1K release 5.0. Incoming call and CLI is working ok. Except DOD CLI, it is showing the master number rather the DOD number. We raise a ticket with TELCO and they said that our switch is sending TON as Unknown
Type_of_Number(Ton Unknown), it should show international.
can somebody guide how to send out TON as INTERNATIONAL.
 
You need to create a DMI that sets the CTYP to INTL. Assign this DMI to your RLI and your calls should be markes as international.
 
We are using route access code directly for dialout. No LD 86 /87/90 stuff.
Can you please help how may i send out International, below is the D channel capture

DCH 11 UIPE_OMSG CC_SETUP_REQ REF 0000001E CH 1 30 TOD 11:36:44 CK BB1C2663
PROGRESS: ORIGINATING END IS NOT ISDN
CALLING #:273 NUM PLAN: E164 TON: LOCL
CALLED #:465787 NUM PLAN: E164 TON: UNKNOWN
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top