DOD problem

[lapakhora]

Gi all, We have a DID pri working at CS1K release 5.0. Incoming call and CLI is working ok. Except DOD CLI, it is showing the master number rather the DOD number. We raise a ticket with TELCO and they said that our switch is sending TON as Unknown
Type_of_Number(Ton Unknown), it should show international.
can somebody guide how to send out TON as INTERNATIONAL.

 

[allenmac]

You need to create a DMI that sets the CTYP to INTL. Assign this DMI to your RLI and your calls should be markes as international.

 

[lapakhora]

We are using route access code directly for dialout. No LD 86 /87/90 stuff.
Can you please help how may i send out International, below is the D channel capture

DCH 11 UIPE_OMSG CC_SETUP_REQ REF 0000001E CH 1 30 TOD 11:36:44 CK BB1C2663
PROGRESS: ORIGINATING END IS NOT ISDN
CALLING #:273 NUM PLAN: E164 TON: LOCL
CALLED #:465787 NUM PLAN: E164 TON: UNKNOWN