Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

DMC Dect card via Serial

Status
Not open for further replies.

Bottylad

Technical User
May 11, 2005
13
GB
I have a DMC8 card which I am trying to communicate with via serial cable. (I do not know the IP address of the card as it has been changed). I have checked that Jumpers J6-J9 are set to v.24. I have cross-connected my serial lead to the krone strip

I have followed GHTrout's procedure but cannot get this to work.

Created new modem connection 38400 - 8 - N - 1
Created new Dial-up connection to use this modem (all as per the procedure).

I get repeated PPP error 721 (remote computer did not respond).

If anyone has successfully done this could you please explain how you did it?
 
From what I remember, you need to use Dect Manager within OTM to access the card via a comm port, once the wiring from the krone strip has been done.

I have a small guide on it, but it could be the same that you have seen?.



All the best

Firebird Scrambler
Meridian 1 / Succession and BCM / Norstar Programmer in the UK

If it's working, then leave it alone!.
 
Thanks for the reply. Yes that is the guide I have been using.

The wiring appears to be correct. I get messages to say

Local modem connection established
Remote modem connection established

Remote PPP peer is not responding
 
Have you restarted the card. You need to restart the card and then you have 10 minutes after the card has restarted to connect to the unit via the default password of Arsenal.

Thanks,
Colin

 
Yes I've tried re-seating the card. I'm trying to do this from an XP machine and not Windows 2000, I'm assuming this should be ok?

 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top