Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

diverting to reception if all lines busy

Status
Not open for further replies.

baldyeagle

IS-IT--Management
Dec 24, 2008
39
GB
i have a DDI number programmed into the switch in the office (ip office403ds 3.2 (67)), divert is always on and it diverts to my mobile. sometimes though it throws up a "218 error please leave a message". i think it is because there are not enough lines in the building and as it cant grab one, diverts to voicemail.

is there a way i can program this to fall back to the reception if the line is not available?
 
If you have VM Pro you can send any calls that are sent to VM to Reception, just put a transfer to Reception in the users leave start point :)

ACS - IP Office Implement

"I'm just off to Hartlepool to buy some exploding trousers
 
Also I have never tried this but it could work, put a phantom/virtual user in a sequential huntgroup and have that user forwarded unconditionally (also huntgroup calls)to the moblile, make sure VM is off on the user and group and turn queueing on for the group, then target the group with the DDI, if all lines are in use the call should queue until one becomes free. As i say it may not work it's just a thought :)

ACS - IP Office Implement

"I'm just off to Hartlepool to buy some exploding trousers
 
you have the mind of a genius Riddle. I will try that, it makes perfect sense. I dont have VMPro only VMLite.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top