Diva Server 4BRI 8M PCI is not working with Trunk Mode!

[marbla77]

I try to integrate MD110 (TLU 79) with Diva Server 4BRI 8M PCI! but this connection is not working!
Does anyone have know the parameters to use with the TLU79 to connect with Diva Serwer 4BRI??
I tried some parameters but without success...
I am using MD110 BC12.

My Route is programmed:

<ROCAP:ROU=17;
ROUTE CATEGORY DATA
ROU SEL TRM SERV NODG DIST DISL TRAF SIG BCAP
17 0110000000000010 5 0000030001 0 30 128 01151515 211110000031 111100

<RODAP:ROU=17;
ROUTE DATA
ROU TYPE VARC VARI VARO FILTER
17 SL60 H'00000214 H'11410000 H'06310000 NO

<RODDPEST=3997;
EXTERNAL DESTINATION ROUTE DATA
DEST DRN ROU CHO CUST ADC TRC SRT NUMACK PRE
3997 17 0005000000000250000000010 0 5 0 3997

In my opinion cable is ok.
When i try call to DivaSerwer, Fax daesn't work.


Thanks a lot,
marbla77

 

[dusyi]

My Route is programmed:
<rodap:rou=all;
ROUTE DATA
ROU TYPE VARC VARI VARO FILTER
5 SL60 H'00000214 H'15440000 H'46300000 NO

END

<rocap:rou=all;
ROUTE CATEGORY DATA
ROU SEL TRM SERV NODG DIST DISL TRAF SIG BCAP
5 7120000000000010 4 2110000000 0 30 128 00151515 111101000031 111111

END

<roddp:dest=all;
EXTERNAL DESTINATION ROUTE DATA
DEST DRN ROU CHO CUST ADC TRC SRT NUMACK PRE
5 5 1505100000000250105000000 0 1 0

END

<aspaparnum=223;
APPLICATION SYSTEM PARAMETERS
PARNUM PARVAL
223 7 (for internal call diversion to Server)
END

Settings for Diva Card:
Line Type: BRI
Switch Type: PBX,Q-SIG
PBX-Type: Ericsson MD110
QSIG-Standard: ISO
Interface Type: Point-to-Point
TEI: 0
Layer 2: permanent

 

[marbla77]

thanks very much!
Everything runing ok.