Distinctive Ringing Opt 11C

[Qamar177]

I have opt 11C, distinctive Ringing is "YES" in route configuration,TTBL is "0".
When there is an incoming call on network phone set is continuously ringing with a small gap. I want to change this gap with higher "on" and "off" time. How to change ?

 

[janaya]

What type of phone? You can change DRG1 - DRG4 in the CLS programming of each individual phone as needed.

John Anaya
Amdocs Inc.
ACSS/ACIS - CS1000 Rls 7.5/Call Pilot 5
ACSS/ACIS - SME - IP Office 8.0
APSS/APDS - Avaya UC Services

Public Profile

http://www.linkedin.com/pub/john-anaya/25/1b9/a9b/

 

[kstaff22]

It's been a long time since this was an issue on the Opt11 but I found my old notes.
The system is probably using WCAD 002 for DCAD in table 0.
Change the settings for wcad 004-
WCAD 4
CDNC 00102 00102 00205 00410 00000 00000 00000 00000 00000 00000-4th field is normally 0819 --this setting will have an acceptable dist ring and will be answered by faxes and modems

then change the DCAD to 004 in table 0
REQ PRT
TYPE FTC

USER

TYPE FTC
TABL 0
NCAD 001
NBCS
XTON 002
DCAD 004-----------------------------this is the dist- ring cadence--default is 2

 

[Qamar177]

Thanks kstaff22, I have configured a new table and inserted dcad 004, now I am going to change the values of wcad 004 by adopting following procedure

LD 56
Req: chg
Type :mcad
Wcad:004
CDNC : 00102

But whenever I insert values ie 00102 space
The following error is received SCH1242.

>SCH1242
Invalid entry. Out-of-range(0-15)

 

[Qamar177]

I changed values of WCAD 4 as mentioned below but same ringing, no change in distinctive Ringing...
CDNC 00102 00102 00205 00410 00000 00000 00000 00000 00000 00000