Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations TouchToneTommy on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

display on ip phones not working properly

Status
Not open for further replies.

jertson

Vendor
Oct 1, 2011
22
PH
i just upgraded the system from CS1000S rls 4.5 to CS1000E rls 7.50Q everything is working fine, except for name display issue. for ip phone 1120 and 1140 no problem, for ip phone 2002 phase 1 and 2002 phase 2, there was a problem, on some phones name will display, for some it won't display. for ip phone 2007 it's not working at all.

i will attach the firmware of the ip phones..any help please

jertson



 
Have you tried a manual reset of the sets i2002's that is i ran into after an upgrade to 7.5Q have to do this to get the firmware out to the sets for some reason some sets get the firmware and others won't.
 
You may also need to force down the new firmware to the phones. Do one the first time to make sure it works. I only had about 20 so I did one at a time and turned 1 into a brick.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top