Disabling STP on Cisco 2948G-L3

[Trunks]

Does anyone know how to disable spanning tree on the 2948 or enable portfast as we cannot find a command to do it. the "bridge-group 1 spanning-disabled" command does'nt work.

 

[wybnormal]

Something is not correct with your config.. if your router is setup right, the only IP the servers/workstations need to know about is the default gateway which should be the router. There is not a reason on the surface to have to add routes to all of these for them to get from here to there..

If you can post the config, we can disect it and see where there may be improvements made

Mike S
"Diplomacy; the art of saying 'nice doggie' till you can find a rock" Wynn Catlin

 

[thekidcisco]

Have you checked the command reference for this on CCO? It should be there...