Got a Nortel MICS with a pri and a t1 and need to make 1 did to be answered by the disa card which is already installed. My target lines have 4 digits (0050 - 0069). When i got to System Programming the auto ans feature will ot let me insert any of those did's. Please help!
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations Chris Miller on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
Disa programing 2
- Thread starter techiq
- Start date
-
1
- #2
jerryreeve
Vendor
what is the software version you are operating the MICS on? the Target lines should start around 145 on most versions.
JerryReeve
Communications Systems Int'l
com-sys.com
JerryReeve
Communications Systems Int'l
com-sys.com
-
1
- #3
techiq:
are those four digits the last 4 digits of the phone numbers? If so, you have those confused with the Logical Trunk Numbers, which, as jerryreeve said, start at 145. Go into programming and enter 145 as the trunk number to program. You can then check out the received digits.
are those four digits the last 4 digits of the phone numbers? If so, you have those confused with the Logical Trunk Numbers, which, as jerryreeve said, start at 145. Go into programming and enter 145 as the trunk number to program. You can then check out the received digits.
jerryreeve
Vendor
If your receiving digits are starting with 0 you also may have a problem since 0 is the direct access number.You may have to drop the received digits to 2 to truncate the leading zeros.
JerryReeve
Communications Systems Int'l
com-sys.com
JerryReeve
Communications Systems Int'l
com-sys.com
- Thread starter
- #5
- Status
Similar threads
- Locked
- Question
- Locked
- Question
