DISA configuration

[MDfreak]

Hello All

how could i establish a DISA connection trough external Analog Trunk, i intiated the DISA function by using:

NANSI:NUMTYP=DI,NUMSE=xxx;
then the AUCOI:AUTH=xxxx,CILCOD=xxxx,CAT=XX;
where xx is the catogry for disa number,
all is ok even when i call from outside the system to dial into DISA extension i hear DISA extension dial tone but when i apply the AUTH. CODE, it doesn't work, it gives silence
DT*75*AUTH# now i should hear the dial tone where could i dial outside or hear a dial tone but nothing,
what's worng?

 

[whosrdaddy]

Hi,

DISA access is controlled through system parameter (ASPAC) 184 :

0 - central auth code is needed
1 - regional auth code is needed (this is what you want)
2 - central OR regional authcode is needed
3 - no authorisation needed (IMHO : never use this as this will open your PBX to the outside world without ANY control)

Cheers

--------------------------------------
What You See Is What You Get

 

[jazaya]

And If you are using a BC release with license,You need it in order to make Disa work.


Experience it, there is no substitute.

 

[Dolphino]

lisence is lodaded and PARNUM=184 is set on Regional Auth. code. is programmed, but i found the problem was in TCMAS where truncks aren'r allowed to call each other.

thanks for replying