Different routes

[crasho2001]

Hi,

I am trying to reach 10.68.49.50.

I can reach through nxge2 interface.

When I down the nxge2, I am waiting to reach 10.68.49.50 via nxge0.
But this is not happening. System tries to reach 10.68.49.50 via e1000g0.
Any suggestion?

Regards,


root@xxb>ifconfig -a
lo0: flags=2001000849<UP,LOOPBACK,RUNNING,MULTICAST,IPv4,VIRTUAL> mtu 8232 index 1
inet 127.0.0.1 netmask ff000000
aggr1: flags=1000843<UP,BROADCAST,RUNNING,MULTICAST,IPv4> mtu 1500 index 2
inet 192.168.0.2 netmask ffffff00 broadcast 192.168.0.255
ether 0:21:28:43:66:ab
e1000g0: flags=1000843<UP,BROADCAST,RUNNING,MULTICAST,IPv4> mtu 1500 index 3
inet 10.79.1.62 netmask ffffff00 broadcast 10.79.1.255
ether 0:21:28:43:66:aa
nxge0: flags=1000843<UP,BROADCAST,RUNNING,MULTICAST,IPv4> mtu 1500 index 4
inet 10.79.9.67 netmask ffffffc0 broadcast 10.79.9.127
ether 0:21:28:33:25:26
nxge2: flags=1000843<UP,BROADCAST,RUNNING,MULTICAST,IPv4> mtu 1500 index 5
inet 10.79.9.3 netmask ffffffc0 broadcast 10.79.9.63
ether 0:21:28:33:25:28
root@xxb>netstat -rn

Routing Table: IPv4
Destination Gateway Flags Ref Use Interface
-------------------- -------------------- ----- ----- ---------- ---------
default 10.79.1.1 UG 1 19
10.68.17.0 10.79.9.1 UG 1 18
10.68.17.0 10.79.9.65 UG 1 0
10.68.18.0 10.79.9.1 UG 1 11
10.68.18.0 10.79.9.65 UG 1 0
10.68.49.0 10.79.9.1 UG 1 4
10.68.49.0 10.79.9.65 UG 1 0
10.68.50.0 10.79.9.1 UG 1 11
10.68.50.0 10.79.9.65 UG 1 0
10.79.1.0 10.79.1.62 U 1 98 e1000g0
10.79.1.61 192.168.0.1 UGH 1 8
10.79.9.0 10.79.9.3 U 1 3 nxge2
10.79.9.64 10.79.9.67 U 1 0 nxge0
192.168.0.0 192.168.0.2 U 1 4 aggr1
224.0.0.0 10.79.1.62 U 1 0 e1000g0
127.0.0.1 127.0.0.1 UH 42 7868 lo0
root@xxb>

 

[hsleem]

hi,

could you please send me the output of the below commands:

#ifconfig nxge2 up
#traceroute 10.68.49.50

then

#ifconfig nxge2 down
#traceroute 10.68.49.50


/houssien