DID Range

[Caballero1]

Hello - Where would the DID range be located in the cisco call manager web admin site?
Thanks

 

[DallasBPF]

depends if you are using MGCP or H323.

if MGCP -

goto the gateway and click on the PRI, about halfway down there is a section for Caller ID DN. that is one place, if you are accepting the entire DID without any type of translation patterns.

if H323 -

you would need to look on the router for that


Another option, contact the PRI vendor to get the information.

------------------------------------
Dallas, Texas
Telecommunications Tech
CCVP, CCNA, Net+

CCNP in the works

 

[Caballero1]

Device> Gateway? This is the only option under the Cisco Unified Cm Administration. Is it maybe under another admin page like cisco unified connection administration?
The above option shows a couple of gateway that can be clicked on but no Caller ID DN section. Thanks

 

[Caballero1]

I went to Call Routing>Route Plan Report. Active phones (that can receive external calls) appear to be on an specific "partition"

The goals is to give a new hire a number that's accessible from the outside, etc. At the moment, his desk phone does have a number but it is not accessible from the outside.

Thanks again

 

[trvlr1]

What you need to do is call your local Telco, the ones providing the DID service and ask them what they are delivering to you as a DID range. When you have that, you can do a print of all your phones and see what numbers are being used and what are available.

 

[OzzieGeorge]

Usually DIDs come in a "hundred" block, you may well have purchased one or more blocks. simply find an extension that has the indial capability and that should point you in the right direction!

 

[Caballero1]

Thanks