I am trying to establish DID off a PRI about 11 are going to be faxes and DIDs and the remaining lines are to be IN/OUT lines for all calls. Please help I am flustered with this situation.
The PRI can be both in and out, usually it is set for CALL BY CALL Service.
This means, in a nut shell, that if an incoming call needs to be routed to an extension, the system routes it that way, based on an Incoming Routing Table, -OR- if an outgoing call needs to be made, an outgoing table is used, but the same lines are used to make it so.
Are you getting a FULL PRI (23B & 1 D)?
Do you have info on what DIGITS the vendor is sending?
I can tell you how it is supposed to be programmed, based on the answers above.
I just spent 2 hours programming one yesterday for a cut in a few weeks.
If not Merlin man anyone who can help me establish outgoing lines on a PRI as well as assign numbers out the PRI to ring a certain ext. or fax or single line
I must ENCODE my address on this forum for obvious reasons.
First off, you know my handle.
2nd, you know how to program a voice mail....
3rd put this together, and you will have it.
email addresses are handle, a sign (WHICH YOU KNOW), an isp (WHICH IS EXPRESSED BELOW IN DIAL CODES), a PUNCTUATION MARK (WHICH YOU KNOW) and a type of isp.
So my address is:
handle, that sign, isp = 23, 63, 61, 23, 21, 74, 81 THE PUNCTUATION MARK and something you catch fish in.
If you can't figure it out, POST, and I'll give hints.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.