Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations strongm on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

DID on Magix 1

Status
Not open for further replies.

jfrancis1958

Vendor
Oct 5, 2006
38
US
Ok, i'm desperate. I have been over every piece of documentation that i can find.

Magix 2.1 here in house. I have never programmed DID's on this particular switch so I'm stumped.

Where/what doc is that detailed? I haven't found it after countless hours.

Can someone PLEASE guide me to a resource?

I'm desperate.

thanks.
 
It's just in the regular Feature Reference. You must program the type (wink, loop) DTMF or Pulse, the number of expected digits. Get them connected, observing polarity, and just renumber extensions to match the DID digits being sent. You can delete and add digits, but matching extensions is the easiest.
 
Thanks TTT.

You are the man.

I was looking too hard. Didn't realize it was that simple. Used to having to program DID's to terminate at extensions or stations...

Working great, thanks again.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top