Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations TouchToneTommy on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

DID not going to nite number 2

Status
Not open for further replies.

mehar1

MIS
Nov 28, 2011
44
PK
I have Nortel CS 1000 but have some problem when I block DID on maximum extensions the problem is the incoming calls are going to different extensions
please guide to solve it
 
Dear firbird scrambler
No I did not change cls to RDC
please guide me
 
How can i divert calls to operator
and how can i change the nite number which is by default 9
i want to give a dn as nite number
 
Wow, you are kinda all over the place. You have no Console but you want the calls to go to the operator? Why would your Nite # be "9" ??????????????????????/
 
I want to replace the 9 with other DN
as i have no operator console
and want other DN
 
Firebird Scrambler
Yes I see it
please guide me how to change it
will it be in LD 86 or any other LD ?
 
In LD 86, do a

REQ CHG
TYPE ESN
CUST 0

Press enter until you get to AC1 or AC2 etc, enter in the new value up to 4 digits long and then press enter until you get to REQ again.

This change will affect all phones.

Firebird Scrambler

Nortel & Avaya Meridian 1 / Succession & BCM / Norstar Programmer

Website = linkedin
 
Wait a minute, why would you want to change AC1? This will affect how you dial out. How did we get from changing the Nite DN to changing AC1?
 
Firebird Scrambler

it did not work
it gives error message
ac1 and ac2 did not defined previously both are blank
 
KCFLHRC (TechnicalUser)

Please guide what i should do to solve this problem
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top