Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

DID forward-Key 1

Status
Not open for further replies.

scs5000

Vendor
May 4, 2008
23
Hi i have a M3904 set on which there are 2 DID numbers are programmed on Key1 and Key2
Key 0 SCR 4240
Key 1 SCR 4233
Now customer need to forward key 1 calls only? i mean some times he use to be at some other extension and before going to other ext he wants to forward his key 1 only on that extension. Is there any setup possible to do this?? he doesnbt wants to forward his set.
PBX is 11c release 4.5
Regards
 
Can't be done, it's all or nothing.




This is a Signature and not part of the answer, it appears on every reply.

This is an Analogy so don't take it personally as some have.

Why change the engine if all you need is to change the spark plugs.


 
key 0 controls the set. could you add an appearence of the other key to where he is trying to cfw it?

Mato' Was'aka
 
I will try GHTROUT suggestions and will be back with result
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top