Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

DIAL TONE ON INCOMING CALL 1

Status
Not open for further replies.

nortelphonegirl

Programmer
Dec 25, 2011
17
US
I received a call from a friend that says when someone dials into their line 1 (copper line) on their BCM, it goes right to a dial tone. (I'm thinking a DISA may have been set up on this line). Can someone tell me how to check to see if it's set up on DISA and how would I stop that from happening?

Thanks
Kate
 
Jeremy.. Thank You. I'm a Norstar and Option 81 person and I"m not on site. Can you give me a little more direction? I don't even know how to log in remotely to a BCM to help them.

Kate
 
Programming via telset is same as Norstar

I am a bit foggy on exactly where, it's in the guide though.

Lines/XXX/Answer with DISA = NO
SystemProgramming/Dialing Plan/DISA DN = None



=----(((((((((()----=
curlycord
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top