I have my core and an lsp hanging off of it and I'm having issues with dial plan transparency. On the IP-network-region page 3 I have the incoming LDN extension setup with a DID and I'm inserting the 1+areacode+exchange and have the dial plan transparency in survivable mode flagged to y. I have the same setup with the LSP location. When the WAN link is fractured and I try and call 4 digits the call says 'display name SV' and then does nothing and disconnects. I do a list trace on the source station and I get a denial event 1224. I then make an ars entry to use a different carrier and then I get the same thing. What is causing these 2 circuits to make the D channel connection?
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
dial plan transparency
- Thread starter wpetilli
- Start date
Just double checking but you have PRIs connected at both sites and while the WAN link is down, you've confirm the gateway registers to the LSP? Lastly, on page 5 of system-parameters features, there are two options that must be stroked to 'y':
Enable Inter-Gateway Alternate Routing? y
Enable Dial Plan Transparency in Survivable Mode? y
Enable Inter-Gateway Alternate Routing? y
Enable Dial Plan Transparency in Survivable Mode? y
- Status
Similar threads
- Locked
- Question