Dial Plan error

[Jay2003]

Currently I have set up a dgt of the following

=========
del 1
inst 1601
=========

This is for a least cost routing entry, However when looking at the raw cdr data I have entries of 1611 and 1620.

I have checked all the SPN and DMI tables with no luck, Also I have checked for any pretranslation lists but there are none configured.

Is there anywhere else that these entries could be getting picked up from.

Regards

Jason

 

[johnpoole]

what digits are the users dialing? are those numbers in as a cdp, spn ?

john poole
bellsouth business
columbia,sc

 

[Jay2003]

9 with ac1 and 8 with ac2,

The only cdp that I have is a 4 digit steering code,

3110 = 0117300 3110

Jason

 

[johnpoole]

i missed something, to reach your party, you dial 9+?

john poole
bellsouth business
columbia,sc

 

[Jay2003]

If I dial 9, 0117 972 4400 I see the following CDR output

9161101179724400

Where it is getting the 1661 from I have no idea

 

[johnpoole]

on your cdr set you have included the acod for the route. look at the dch output, enl msgo x for that dchannel to see the actual digits output to the far end.. use that command under light traffic

john poole
bellsouth business
columbia,sc

 

[janchundia]

Check your route
ld 20
req prt
type dnb
cust 0

dn 1611


Then print the route and check the OPD prompt.
Change YES to NO for fix your problem and verify your CDR register.

Regards,

Javier

 

[vztech]

Does the call complete? You could turn on your DCH messaging in LD 96 and see what digits are being outpulsed if you have a pri.