Dial-back on a BRI to a single NT Workstation!

[BusinessPhoneSystems]

I have got to setup a small router for allowing remote access to a network over isdn for a single remote user.

I don't realy want to get ino lots of complicated authentication due to the single user, and thus standard chap with username and password specified globally would do the job.

However, for the purposes of call costs I would like call back to the remote user!

Any quick config suggestions, snipits or url's would be greatly appreciated!
Regards

Richard [sig][/sig]

 

[Kerzon]

Well, to make a long story short try:
1.

http://www.cisco.com/warp/public/793/access_dial/async_ppp.html

For router to PC callback..

and
2.

http://www.cisco.com/warp/public/793/access_dial/isdn-ppp-callback.html

for ISDN callback...

G/L!

Andy ;-)

 

[Kerzon]

Sorry to make this a 2 parter...

but if you want to use caller ID..

http://www.cisco.com/univercd/cc/td/doc/product/software/ios120/12cgcr/dial_c/dccallid.htm

has some very good information..

Ciao!

Andy }

 

[BusinessPhoneSystems]

Thank you for that, I will give it a while.

Regards

Impreza